Peptide Calculator
Enter the vial size, how much bacteriostatic water you added, and the amount you want per draw. The calculator reports where that lands on an insulin syringe.
What is the total volume of your syringe?
Printed on the barrel. Insulin syringes are marked in units, at 100 units to the millilitre.
To draw 250 mcg, pull the plunger to 7.5 units on your 1.0 mL syringe.
- Concentration
- 3.33 mg/mL
- Per unit
- 33.3 mcg
- Draw volume
- 0.075 mL
- Draws per vial
- 40
For research purposes only. Not for human consumption. All products are sold strictly as in-vitro laboratory reagents to qualified researchers, and are not drugs, foods, cosmetics or medical devices. They are not intended to diagnose, treat, cure or prevent any disease, and must not be administered to humans or animals. You must be 21 or older to purchase.
Reconstituting a vial
Lyophilised powder has to be dissolved before any of the arithmetic above applies. These are general laboratory handling notes for research material.
Work on a wiped-down surface with nothing on it but what the procedure needs. Sterility is the whole game here: a solution that picks up contamination on the bench stays contaminated for the entire life of the vial, and nothing later in the process removes it.
Have the lyophilised vial, bacteriostatic water, a sterile syringe, alcohol swabs and gloves laid out before you start, so that no step is done one-handed while reaching for something.
Take the powder and the solvent out of cold storage and let them come up to room temperature before combining them. Cold solvent dissolves lyophilised material slowly and unevenly, which is what produces the stubborn clumps that get mistaken for a bad vial.
Swab the rubber stopper on both vials with alcohol and let it dry rather than wiping it off.
Draw the volume you entered above, then hold the vial at an angle and let the water run down the inside wall rather than jetting it directly onto the powder. Peptides are fragile in solution, and a hard stream foams them.
Let it dissolve on its own. Swirl gently if it needs help. Do not shake — foam on the surface is denatured material, and it is not coming back.
Unreconstituted powder is the stable form and should stay cold and dark until you need it. Once it is in solution the clock starts: refrigerated, most peptides hold for a few weeks; frozen, for a few months.
Freeze in single-use aliquots rather than repeatedly thawing one vial. Each freeze-thaw cycle costs potency, and the loss does not announce itself — the solution looks identical either way.
Looking for a particular compound? Browse the catalogue, or ask us what documentation exists for the lot in stock.